infra:tools:bambulabx1c
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
infra:tools:bambulabx1c [2023/08/11 16:13] – nicariim | infra:tools:bambulabx1c [2024/04/20 21:58] (current) – removed pl0myk | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | **Placeholder, | ||
- | |||
- | ===== Spec ===== | ||
- | |||
- | | **Build Volume (W×D×H)** | 256 × 256 × 256 mm³ | | ||
- | | **Nozzle** | 0.4 mm | | ||
- | | **Hotend** | All-Metal | | ||
- | | **Max Hot End Temperature** | 300 ℃ | | ||
- | | **Max Build Plate Temperature** | 110℃ | | ||
- | | **Max Speed of Tool Head** | 500 mm/s | | ||
- | | **Max Acceleration of Tool Head** | 20 m/s² | | ||
- | |||
- | [[https:// | ||
- | |||
- | ===== Getting started ===== | ||
- | |||
- | ==== Installing BambuStudio ==== | ||
- | |||
- | Generally, all slicers are supported, however, best support is provided by [[https:// | ||
- | |||
- | Windows and MacOS versions should be pretty straightforward to install, instructions below are for Linux version, tutorial will be based on Ubuntu but feel free to add your own notes for other distributions. | ||
- | |||
- | <TODO installation steps> | ||
- | |||
- | ==== Initial configuration ==== | ||
- | |||
- | BambuStudio has some sane defaults for whatever you're doing, but you must choose the initial configuration correctly. Notably, make sure you're using correct nozzle size and choose correct printer when installing. | ||
- | |||
- | ==== Slicing and uploading the gcode ==== | ||
- | |||
- | ==== Preparing for printing ==== | ||
- | |||
- | ==== Changing filament ==== | ||
- | |||
- | Filament is pushed from behind the printer, it might be hard to reach so see the picture to figure where it is: | ||
- | {{ infra: | ||
- | To change the filament, go to the appropriate menu on the printer and select **unload** to remove the current filament, or **load** to load the new one. | ||
- | {{infra: | ||
- | |||
- | When loading the filament, you will be prompted to push the filament through the tube. Push it until you feel resistance, and then Bambu should detect it and try pulling it. There will be a modal which will ask you if the filament is being pushed - click **Retry** and check by holding the filament if it is getting pulled. If all is well, click **Done** and wait for it to finish | ||
- | |||
- | |||
infra/tools/bambulabx1c.1691770402.txt.gz · Last modified: 2023/08/11 16:13 by nicariim