infra:tools:kodakportrait
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
infra:tools:kodakportrait [2024/02/11 22:03] – ar | infra:tools:kodakportrait [2024/03/02 16:52] – ar | ||
---|---|---|---|
Line 7: | Line 7: | ||
* the stock print surface is a mirror, so try not to break it when removing prints or anything | * the stock print surface is a mirror, so try not to break it when removing prints or anything | ||
* the stock nozzles aren't hardened. don't print filament with additives using them. | * the stock nozzles aren't hardened. don't print filament with additives using them. | ||
- | * the printer uses 12V PSU, so heating the print surface takes a while | ||
* the printer uses the hotend on the right as a Z probe | * the printer uses the hotend on the right as a Z probe | ||
* the printer has been klipperified (WIP)! stock slicer won't work anymore! | * the printer has been klipperified (WIP)! stock slicer won't work anymore! | ||
Line 45: | Line 44: | ||
</ | </ | ||
- | Adjust for macro expansion rules of your slicer. | + | And this for finishing the print: |
+ | < | ||
+ | FINISH_PRINT | ||
+ | </ | ||
+ | |||
+ | Adjust for macro expansion rules of your slicer. As far as I understand, re-creating these in cura-based slicers may not be trivial. | ||
===== Hardware documentation ===== | ===== Hardware documentation ===== |
infra/tools/kodakportrait.txt · Last modified: 2024/03/04 22:10 by ar