Differences

This shows you the differences between two versions of the page.

--- infra:tools:kodakportrait [2024/02/11 22:03] – ar
+++ infra:tools:kodakportrait [2024/06/26 17:38] (current) – [Current status] ar
@@ Line 3: / Line 3: @@
 ===== Current status =====
   * configuration still in flux, is editable from the web ui as needed
+  * not operable; todo:
+    * <del>active cooling for the electronics compartment</del> maaaybe done?
+    * Z offset configuration
 ===== General notes/instructions =====
-  * the stock print surface is a mirror, so try not to break it when removing prints or anything
+  * the stock print surface is a mirror, so try not to break it when removing prints or anything.
-  * the stock nozzles aren't hardened. don't print filament with additives using them.
+  * if printing pet-g, wait for the bed to cool down before removing the print, and/or use glue to provide a debonding agent. washing the bed with cold water also works.
-  * the printer uses 12V PSU, so heating the print surface takes a while
+  * the nozzle on the right (T0; default) is hardened steel; filaments with additives *should* work, but not tested yet
+  * web interface is available at http://kodak.waw.hackerspace.pl/
   * the printer uses the hotend on the right as a Z probe
   * the printer has been klipperified (WIP)! stock slicer won't work anymore!
@@ Line 45: / Line 49: @@
 </code>
-Adjust for macro expansion rules of your slicer.
+And this for finishing the print:
+<code>
+FINISH_PRINT
+</code>
+Adjust for macro expansion rules of your slicer. As far as I understand, re-creating these in cura-based slicers may not be trivial.
 ===== Hardware documentation =====