infra:tools:kodakportrait
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
infra:tools:kodakportrait [2024/02/11 22:03] – ar | infra:tools:kodakportrait [2024/03/04 22:10] (current) – ar | ||
---|---|---|---|
Line 5: | Line 5: | ||
===== General notes/ | ===== General notes/ | ||
- | * the stock print surface is a mirror, so try not to break it when removing prints or anything | + | * the stock print surface is a mirror, so try not to break it when removing prints or anything. |
- | * the stock nozzles aren't hardened. don' | + | * if printing pet-g, wait for the bed to cool down before removing |
- | * the printer uses 12V PSU, so heating | + | * the nozzle on the right (T0; default) is hardened steel; filaments with additives *should* work, but not tested yet |
+ | * web interface is available at http:// | ||
* the printer uses the hotend on the right as a Z probe | * the printer uses the hotend on the right as a Z probe | ||
* the printer has been klipperified (WIP)! stock slicer won't work anymore! | * the printer has been klipperified (WIP)! stock slicer won't work anymore! | ||
Line 45: | Line 46: | ||
</ | </ | ||
- | Adjust for macro expansion rules of your slicer. | + | And this for finishing the print: |
+ | < | ||
+ | FINISH_PRINT | ||
+ | </ | ||
+ | |||
+ | Adjust for macro expansion rules of your slicer. As far as I understand, re-creating these in cura-based slicers may not be trivial. | ||
===== Hardware documentation ===== | ===== Hardware documentation ===== |
infra/tools/kodakportrait.1707689002.txt.gz · Last modified: 2024/02/11 22:03 by ar