Hostname choice is a reference to Yamata no Orochi, mostly becaue of the planned INDX upgrade.

The printer's left at the hackerspace for the general use by hackerspace members. Feel free to use, but:

• if there's any problem with it, contact ari, preferably highlighting on #druk3d matrix channel.
• there's a printer manual in the accessories box. feel free to consult it if something's unclear.
• printer has automatically operated vent holes on top. no need to keep the door open when printing with low-temperature filaments

Filament is loaded from the right side, through the short PTFE tube.

Since it's a Prusa printer, the most well-polished profiles will be present in Prusa Slicer.

Next release of Orca Slicer, whenever that happens, Should™ have them as well (they're merged in git).

Printer is connected to the network using an ethernet cable in the back.

Verify password in settings on the printer itself if in doubt. Avoid clicking “generate”, as this will break settings for other users.

Generally, don't.

• installed the official “advanced filtration” module
• planning to install a Bondtech INDX system on it when that becomes available