Warszawski Hackerspace

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Z-Turn GPIO add-on ======

This board brings out the GPIO pins found on the CN2 connector and routes them through 74LVCH245 buffers out to normally-sized pin headers.

{{:projects:zturn-hackers:render.png?200|}}
{{:projects:zturn-hackers:addon.jpg?200|}}
{{:projects:zturn-hackers:zturn_with_addon.jpg?200|}}

Project repo:
[[https://code.hackerspace.pl/emeryth/zturn_addon/]]

==== Details ====

\\

== Schematic ==

[[https://code.hackerspace.pl/emeryth/zturn_addon/plain/zturn_addon.pdf]]


== Power ==

The board features two ways of powering the buffers, selectable by J1 jumper pins:

  * EXT 3.3V - uses the 1117 linear regulator on the PCB, which is connected to the Z-turn's 5V supply
  * INT 3.3V - uses 3.3V supplied by the Z-turn board

Of course you can connect your own supply to one of the VCC pins if you want to (after removing the jumper).

== I/O Pins ==

The board features five 8-bit bi-directinal buffers - [[http://www.nxp.com/documents/data_sheet/74LVC_LVCH245A.pdf|74LVCH245]].
The direction can be set individually for each buffer.